CRETE-HEAT INSULATED FLOOR PANEL SYSTEMS
The Crete-Heat Insulated Floor Panel System is an easily assembled modular board insulation, vapor barrier, and radiant tube holding grid. It allows for simplified installation of hydronic radiant floor heating systems in basements, garages, main floor slab on grade and above grade installations where concrete or gypcrete is normally used. Each interlocking panel, available in either 1 inch or 2 inch thicknesses of Expanded Polystyrene, covers up to 8 square feet with fasteners for 1/2″, 5/8″, 3/4″ and 7/8″ radiant tubing. A 10-mil High Impact Polystyrene film thermoformed on to the EPS Foam provides the vapor barrier. Visit www.crete-heat.com for further information. Proudly made in the USA. *****ADDITIONAL NOTES REGARDING VIDEO***** Laying of the panels showing the ship-lap interlock backwards was due to a last minute request to videotape. Some of the panels were taken up to begin videotaping that segment again and the panels were from the end of the building where the last panels were installed,resulting in what showed the ship-lap being backwards.Proper install is with the male half of the ship-lap facing upwards and the female portion connecting into it as the panels are installed. First time users loved this product. The project called for 2″ of insulation but the Crete-Heat Panels, which were donated for this job, were only available at the time in 1″, so the other 1″ insulation was used underneath to obtain the 2″ overall thickness.
Video Rating: 4 / 5